4 Simple Guidelines to Oiling a Paper Shredder

 

Steps to oiling a paper shredder start by checking the oiling needs of the gadget, utilizing the right type of oil, putting the right amount of oil, and spreading the oil.

Paper shredder machines are significantly becoming popular in households and offices due to the security they provide from identity thieves. Nonetheless, just like any other device, these gadgets require regular maintenance to constantly and efficiently serve its purpose, like oiling. Fortunately, oiling these gadgets is very simple to do. Just read this article to know how.

Check the oiling needs of the machine

Depending on the degree of security your paper shredding machine can provide, the more secure it is, the more it has to be oiled. Thus, in other words, strip-cut paper shredders require the very least oiling, and those units used in high security locations need the most. This is because the smaller the pieces of paper are cut, the more dust is produced, which eventually accumulates on the cutting blades. Strip-cut paper shredders cut less paper as compared to its higher end counterparts, and hence produce only less dust each time the appliance is utilized. Dust also typically accumulates in time and whenever the unit is often utilized. Most manufacturers would advise oiling your unit every thirty minutes while being utilized to an hour. A good tip would be to oil the shredder about 3 to 4 times per week if you rarely use it, and to follow the instructions of the manufacturer if the unit is frequently used.

Use the correct kind of oil

According to paper shredding phoenix, it is necessary to use the right kind of oil, one that is purposed specifically for your unit and recommended by its manufacturer. You can not just use any kind of oil because the oil meant for these units are needed to be heat tolerant and must also have been calibrated specifically for these units.

Apply the right amount of oil

Apply oil onto the blades, from one end to the other, at the blade opening for approximately 2 seconds. This should be long enough for the correct amount of oil to lubricate the cutting blades, because applying too fast might result in an insufficient amount of oil, and too slow may also result in too much oil on the blades of the shredder. Paper shredder lubricating oils also come in different forms of containers. So, depending on its bottle, run, squirt, or spray the oil onto the blades of the unit.

Spread the oil

Distribute the oil you applied onto the blades of the shredder by turning the unit on the manual mode and pressing the “Reverse” button. Let the blades run this direction for a couple of seconds, then press the “Standard” or “Forward” button. Let it run in this direction too for a few moments. Running the unit in both directions will allow the oil to be spread through the entire shredder unit. After you have placed oil directly onto the blades, you may also shred a piece of paper with oil to be sure that oil reaches all sections of the cutting blades. To do this, just squirt or spray a piece of paper with oil in a zigzag pattern. The zigzag pattern is important to make sure that oil does not easily get soaked into the paper before any of it can reach the cutting blades. You can also feed the unit another oiled piece of paper to be sure that the blades are now well lubricated.

It is vital that you use the oil suggested by the manufacturer of the unit so as not to nullify its warranty. In addition, if your unit has not been functioning properly, it is advisable to bring this to its service center instead of trying to fix it on your own.